Legend009 Posted October 7, 2017 Share Posted October 7, 2017 Can an ep82 ecu work with an ep91 4efte engine? Quote Link to post Share on other sites
5e colin Posted October 7, 2017 Share Posted October 7, 2017 yes just make a jumper loom and make sure the ecu temp sensor wire is amended ( 3plug ) gtt 2 plug , i believe 1st gen V is same sensor i think and the 98-00 is the 3 wire 1 some 1 will comfirm about the sensor Quote Link to post Share on other sites
Sudden Posted October 12, 2017 Share Posted October 12, 2017 the 3 pin temperature sensor is basically the 2 wire sensor + the single wire sensing unit put together to reduce the number of units on the thermostat housing. The 2 pins that are side by side are the pair for the ecu, and the single at the top goes to the gauge. Quote Link to post Share on other sites
Legend009 Posted October 26, 2017 Author Share Posted October 26, 2017 I’ll check on that. I got a 4efte glanza V engine but without the harness and ecu. I got an ep82 harness and the glanza ecu, however a friend of mine has the EP82 ecu and is willing to give it to me since he is using an aftermarket one. Are there any bypasses to be done if am going with this setup? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.