5e colin Posted October 11, 2017 Share Posted October 11, 2017 (edited) lads i need to fill a 5" hole in the bumper im sick of looking at it something needs fixing can yous give me some tips on bonding it without it peeling off Edited February 5, 2018 by 5e colin Quote Link to post Share on other sites
5e colin Posted February 5, 2018 Author Share Posted February 5, 2018 Bump Quote Link to post Share on other sites
maerijn Posted February 5, 2018 Share Posted February 5, 2018 is it a GT bumper Colin or N/A? The N/A are a pain to work on, shit plastic material Quote Link to post Share on other sites
5e colin Posted February 5, 2018 Author Share Posted February 5, 2018 Sadly in a gtt bumper Quote Link to post Share on other sites
5e colin Posted February 9, 2018 Author Share Posted February 9, 2018 lets see if it works Quote Link to post Share on other sites
maerijn Posted February 9, 2018 Share Posted February 9, 2018 Not sure about the temperature over there but maybe best to let it cure inside? Quote Link to post Share on other sites
5e colin Posted February 9, 2018 Author Share Posted February 9, 2018 Did that 20 min after I took pic feck me the whole house stank like fibreglass the missis was not happy ha ha turned out OK ish needs some Sandi g and filler on the outside not bad for first time . better application tools would be handy like minni roller and bigger brush Quote Link to post Share on other sites
rob_bower Posted February 13, 2018 Share Posted February 13, 2018 A light keying with rough paper will help also a small drill bit through so they’re ar a few holes so some of the resin runs through can also help it grab. At that size I would have been tempted to mesh it to. Or just build a few layers of glass up. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.