Jump to content

Recommended Posts

I have been looking to get some cams for my na build. Was looking into getting oe cams sent to be reground which means new shims will be needed but for a little extra cost the there is the billet cams by speedvision. Other than that I'm not sure where to get any other cams. Does anyone have any experience with the speedvision cams are they any good and do they require reshimming? 

Edited by JDM_MARK
Link to post
Share on other sites

Any set of cams you swap out will need reshimming whether they are standard or aftermarket.

Inlet clearance is like 0.15mm to 0.25mm, exhaust is 0.25mm to 0.35mm so you've only really got 0.1mm to play with. If you start switching parts its not hard to sway either side of the tolerances so you will have to check all 16 valve clearances again are re check

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...