ZEROPILOT Posted September 14, 2018 Share Posted September 14, 2018 Yes and no. The KP61 steel, JDM type bumper is all but impossible to find here in the U.S. So out of desperation I ordered a new KE70 Corolla bumper for the rear. I had already sourced rear brackets from England (Ebay)for a KP60. The KE bumper needed to be cut 1" on each end and all of the original holes filled/welded closed. Then the bumper was shot in flat black urethane paint after the new mounting holes had been drilled. Then the KE70 bumper end caps where cut and shaped the contour of the KP61. Built up with flexible epoxy and painted crinkle black. Quote Link to post Share on other sites
ZEROPILOT Posted September 14, 2018 Author Share Posted September 14, 2018 More photos once it's all assembled and done. Nice. Yes. Perfect fit? No. But a whole lot cleaner than the U.S. spec gigantic, plastic units. Quote Link to post Share on other sites
ZEROPILOT Posted October 4, 2018 Author Share Posted October 4, 2018 Quote Link to post Share on other sites
ZEROPILOT Posted October 4, 2018 Author Share Posted October 4, 2018 It's ok But I'm still looking for a correct JDM unit. Quote Link to post Share on other sites
ZEROPILOT Posted October 7, 2018 Author Share Posted October 7, 2018 This is the front Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.