Jump to content

elison

Member
  • Content Count

    3
  • Joined

  • Last visited

About elison

  • Rank
    Newbie

Profile Information

  • Gender
    Male
  • Location
    Aruba
  1. Nice setup buddy. I hope this buidl is still going on. I have build a similar setup but with a GT2860rs with a Elite 1500 ECU. I have to tell you its a pretty solid ECU. Got the dash and some other stuff coupled via can bus. If i could be of any help for information exchange you can shoot me a message here or on facebook Elison Mercera. https://www.facebook.com/BellosGarage/photos/pcb.761219087364309/761219057364312/?type=3&theater Cheers
  2. I had the same problem. But i got it sorted out. There is a washer inside that is supposed to hold a spring on one side of the mechanisem but i think due to again or worn pads it could have slipped top the other side of the spring. You just have to take out the piston and you find it with the auto adjust mechanisem.
  3. The CTS is m12x1.5. And the IAT is a little smaller than 3/8npt.
×
×
  • Create New...