-
Content Count
29 -
Joined
-
Last visited
About lukebrown4321
-
Rank
Member
- Birthday 07/19/1992
Profile Information
-
Gender
Male
-
Location
grantham
-
my first year will be there in the starlet but not on the club stand was too late. should be a good weekend
-
I've bought my ticket but now I can't make it???
lukebrown4321 replied to raddys1's topic in Show Archives
I will have one for sale once I receive it -
how did you fit the side skirts on I've got some but still need to spray them before fitting.
-
Had some spare time today so decided to fit my 4-2-1 manifold. Before fitting gave it a coat of Calyx manifold dressing just so it didn't look brown n rusty.
-
corolla manifold on n/a ep91
lukebrown4321 replied to lukebrown4321's topic in Intake, Turbo & Exhaust
Its a cast iron 4-2-1 manifold thats in 2 sections the 4-2 section has a lambda sensor hole then there is a separate 2-1 section think its from a toyota sera not a corolla Thanks will have a proper look at it tomorrow -
i have fitted the corolla 4-2-1 mani to my starlet and the lambda sensor hole is in a different place so the lambda sensor no longer reaches just wondering if it will pass an mot without the lambda sensor or will i need to extend the wires thanks
-
I have got some 40mm lowering spring and am just wondering how much the rear axel will move by. I know I would need to adjust the panhard rod (making an adjustable panhard rod) but not sure how much would need to chop out
-
Dont forget a intake manifold gasket while your on there
-
Just need the manifold everything else matches up. corolla manifold is just a straight swap bolts out swap over and bolts in. Taking the fuel rail off will also make it abit easier to do but not necessary
-
I have recently fitted the corolla inlet manifold and yes i would say its a must do mod for the n/a nice increase in low down torque not huge but its noticeable
-
Nope they are the jdm ones ;) someone on here is currently selling a jdm engine and its there the same colour
-
Got it from fiddlersport a member on here just put up a wanted ad and someone should reply with one or go to the local scrappy and look for a bug eye corolla
-
I think its because the rubber throttle cable mount is too thick so going to get 2 1 inch by 1 inch thin metal plates to replace it which should fix it
-
haven't driven it yet mate will go out abit later to try it, got to make a few tweaks to throttle cable first as cable is tight and idle's at around 2000 rpm due to the mount being further across than the starlet inlet mani