Luke91

Hey guys I have a ep82 mk2 with the engine out my glanza now I've had loads of issues like coolant sensor short that's no fixed the fan is constantly on I've done the a/c bridge but it's still on but tbh that dosent bother me. But my speedo is in kph and I can only Rev to 4K then it hits limiter now it's not the engine stalling there it's the actual Rev guage giving me wrong signal anyone had this issue before? No eml lights on nor codes starts on the key just Rev guage playing up

You willing to split? If you are I need some random parts lol. Drivers interior door handle and gear gaitor

I've plugged it in and still the light stays on tho 😂 I'm so lost haha the car behaves fine. I'll swapped the wires around but all that does is makes the temp guage start at the top not bottom.

Cheers mate I know it's code 22 temp switch open or shorting but I don't know how to fix it 😂

Ok guys dropped my glanza engine into the gt everything is plugged in apart from one spade on the water house of under the distributor cap it's the one closest to the car. Run runs fine tbh but the lightvwont go out how do I reset ecu?

Hi guys I have a set of sti bucket seats to go in my gt but do I need starbo rails? I got the sti ones but not gt rails is there a way to fit them into place?

Cheers mate I'll have a good read of your thread then order everything I need lol

Cheers mate only looking for a cheapish upgrade really to standard shocks. Fitted coils to my glanza then wrote it off ten mins later 😂 So saving penny on the gt ATM lol

Hey guys who done the budget build? Does anyone know remember seeing the thread a while ago but lost it now

Hey guys looking for a set of gt seats front ones cheers

Anyone selling a set of front seats for a gt ?

Sorry I know what you mean now lol. Haha ok I'll look into cheers it's mild steel so it should be pretty sturdy

Collector? Lol

How would I work the flow out tho? Cheers

Hey guys basically been digging around for parts and I've found a spare ramhorn manifold now I was wondering weather I could cut the hole and weld the pipe and flange for a external waste gate ? Yes I know you can buy them This is purely and experiment for fun really ? Do I need to take location in for account or angles? Many thanks.