Jump to content

J0n4th4n0

Club Member
  • Content Count

    40
  • Joined

  • Last visited

About J0n4th4n0

  • Rank
    Member
  • Birthday 12/26/1993

Profile Information

  • Gender
    Male
  • Location
    dersingham

Recent Profile Visitors

1632 profile views
  1. Ouch what happened? I have some.... Some are a bit sticky tho 40quids plus postage they yours
  2. FOR Sale Fujitsubo Power Getter £380 ONO plus postage
  3. Hi all sadly im selling my glanza V As is seems to be always the case im selling due to personal circumstances requiring me to have a "propper adult car" . Im staying in the family tho toyota Estima ;D So my 1998 Glanza V It was imported in 2016 By DCI Europe and was bought by the previous owner who used for track days, and only put a couple kms on it in the process. i Bought it @ 108km ~(67k mile) its currently on 126km as it been my daily for almost 12months. Engines Runs great bearly uses any oil. i have done 2 oil changes in my ownership, mot which it p
  4. As title happy to pickup
  5. Will be weighing up my options over the next week, need to stop and figure out what I'm doing I have been pushing something I need more time to complete. Thank you Padders for offering the help and to rest of you with all your feedback. won't give up her! Namaste Joe
  6. Yeah 2 f ups in a row. I guess I just really wanna see it myself, experience what it was to do that, and forever know that part of your car. But I can venture beyond my knowledge/ability and stuff like that happens. Yeah bathroom silicon.. something did tell me I shouldn't but I couldn't understand why. + I had read on some pistonheads thread it was the "ok" thing.
  7. So I don't want this thread to become a fail thread of all the stupid things i'v done to my car, which I can't deny it entirely isn't. Im sure most of you these kinda things probably are elementary. Too much silicon, left it 24hr to set before torquing but was still liquid, dispite looking the part from the outside after a couple bolts at 8nm it was everywhere where it shouldn't. Well off to go learn myself, enjoy. (Probably just a beer tho)
  8. Thanks for all the good advice bottom end back on for meanwhile. Till bearings come and new rod comes
  9. I guess I hadn't... Any pinches of salt were still a under seasoned wrench operator. Thinking I'm going just remove rod check for damage clean up surfaces and replace bearings. Heres some more Picts of stuff I've done/ stuff I've collected: PS thanks idrees for the fujitsubo fits a dream
  10. What does UKSO think do I drive? I'm thinking it looks worse than it is. I'm happy I took the sump of tho was a lot of swarf in there kinda disappointed in MCM: how to turbo. drilling sump without dropping, I wouldn't recommend even if I hadn't hit my rod I would had swarf in there can't be good. Maybe some more would have come out with running a lot of oil through but not worth IMO.
  11. Well I guess that clears up any hard dessions
  12. Well I guess it's time too spill the beans. This is now a turbo conversion thread. So I've been collecting parts over the last couple of months got a ct9 turbo, emanage blue fujitsubo power getter cat back Tien lowering springs, sard rrpfr, mx5 265 injectors, glazna head, gasket kit head bolts and oil filter relocation for oil feed Started some of the but have done a couple of woopies first off modifying the stock manifold with the ct9 flange was a mistake leaves the cat back too low in the exhaust tunnel. And would have been easier to we
×
×
  • Create New...