turbo Grant

I do have 2 sets of skirts, 1 uncut front lip, 1 cut front lip and 1 rear lip. But not for sale

I fitted an ep82 one on my ep70. I had to weld some extensions on the end of the bar. So that you can bolt the drop links on. Ran that for a while till I got hold of a GAB 24mm one

Try efi main relay

Think I only had to move a couple of wires for the indicators and couple of the dash light wires. Also added an earth for the elimination lights. Was really simple following the tracks on both clusters

Is that the same as the torque for the standard wheels

It's the torque for all wheels on starlets.

Another vote for copper plugs

103nm

Nothing wrong with alloy wheel nuts. I'v taken loads of wheels off and on with them on. No problems at all. It's just the idiots who tighten them up without a torque wrench!

Picked up a new work horse today. The drive home was silky and quite compared to the ep70 turbo daily!

Will no most likely end up with a fair few mods...

1.6mm red 100a see what happens

It's all bout the suspension mods. Cars looking clean

i would say a baffle sump is a good insurance. The 4e GT sump I use does not like right hand bends. I quite often watch my oil pressure drop and have to back off. I am using the worst sump tho. Need to change to a Glanza sump with baffles. I'm only running ad08r's on a pretty well set up car.

What wilwood kit you nunning? Looks the the offset on the discs/ brackets is a bit out. I'v not had this problem with the 3G kits on several cars

Fits perfect, just 2 of the front top mount holes need to be wider on each side.

Welcome along. One on eBay I see

I don't have a pic, but could possibly pull my dash to have a look over the next couple of days. From memory know it was the illumination earth wire needed adding, and something else. It was a very easy job to get it all working. Even my economy light worked

Yeah tacho worked without mods as well

Plugged straight into my ep70 loom. Think I had to swap a couple of wires round for the lights.

Not too far from me

I would recommend bolting stub axles on. That way you can shim them up the get suspension get just right

>https://www.youtube.com/watch?v=oCJljDbN40w

I drove that car without a diff. It was bonkers lol

Where'd you get the 71 mid spoiler?

Got it sent from Australia!

That's been cut up for panels lol

Check or replace plugs. Gapped to .7mm and make sure your leads cap and rotor arm are in good order

It's all about screamer pipes and clunky diffs for dailys lol

So sort of an update. More parts for the sensible daily lol

Been running the hrf 4e will not die engine for over 2 years now! And it's cost me so much in oil lol

And I couldn't resist this when i see it for sale! Will make a nice change from my modded gt bar

Lots to get done over winter. Be thinking of getting a roll cage, you can feel the whole car flex round corners lol Might have to get a new daily.