Azz Posted August 14, 2012 Share Posted August 14, 2012 (edited) Ok so going to be fitting my EBC this week and need a few of questoins answerd,What spring do need in my wastegate if i want to run 0.7 and 1.1 bar through my EBC?Where does my pressure sensor go ? ( not my solenoid valve )What hole does it connect too on my wastegate ?Cheers Aaron Edited August 15, 2012 by Azz Quote Link to post Share on other sites
StuDoc 72 Posted August 14, 2012 Share Posted August 14, 2012 Im not an expert but spring wise you need anything below what youd like to run so if you want 0.7 bar cud have a 0.6 bar or 0.7 bar spring and use the EBC to run 1.1. as for the valve im not sure sorry. Quote Link to post Share on other sites
AdamB Posted August 14, 2012 Share Posted August 14, 2012 You want as strong spring as possible, don't forget you can't run lower than base spring pressure. I would stick a 0.7 bar spring in there, and just use the EBC to run 1.1 bar, and turn it off when you want to run 0.7 Quote Link to post Share on other sites
Azz Posted August 14, 2012 Author Share Posted August 14, 2012 Would a 0.5bar spring be strong enough to hold 1.1 bar through the boost controler do you think ? Quote Link to post Share on other sites
Azz Posted August 15, 2012 Author Share Posted August 15, 2012 Bump Quote Link to post Share on other sites
A L 3 X Posted August 15, 2012 Share Posted August 15, 2012 As far as I know you can only go double the spring rate with an Ebc and not more Quote Link to post Share on other sites
Hawwy Posted August 15, 2012 Share Posted August 15, 2012 No you can go much as u like Quote Link to post Share on other sites
Azz Posted August 16, 2012 Author Share Posted August 16, 2012 Cheers guys just need to figure out the pressure sensor and wastegate now Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.