GordR
-
Posts
305 -
Joined
-
Last visited
Content Type
Profiles
Forums
Wiki
Media Demo
Events
Everything posted by GordR
-
No One?
-
High Spec Forged Starlet/Glanza Budget to suit spec. Message me if you are considering selling Many thanks
-
bump
-
Will be using Wossner Pistons with a -6cc dish. Believed a 0.6mm gasket would keep it around stock comp ratio
-
It will be for a new forged build. Everything will be skimmed etc. Will need to cope with 1.6-1.8bar
-
Are they up to the job?
-
Hi Guys, Has anyone had any experience with the Alamo ASC 0.6 headgasket? Struggling to locate a 0.6 mm gasket
-
These are for a EP91 not Ep82!?
-
Looking for a standard Mk2 Ep82 drivers seat, is the blue trim.
-
Bit of a strange one, Has anyone changed electric window controls to manual I run in a road going class and need to retain standard glass + window control. But would be useful to ditch the weight of electric motors wiring etc. Any thoughts welcome
-
Any one?
-
Looking for a EP91 Short Shifter?
-
Yes had seen those, thought quality would be pretty poor.
-
Does anyone have a T3 flanged manifold? Many thanks
-
Looking for a few items., 1) Optional Glanza Rear Bumper Lip pref in white 2) Glanza rear seats and side panels 3) Speedo and dash surround Thanks
-
Hi Does anyone have a ep91 drivers seat base mount? Thanks
-
Just tried a set of 195 50 15 federal Rsr's. Once they have heat into them they were pretty impressive. And at 52 quid a corner from camskill pretty good value
-
Looking for 195 50 15 or 205 45 16 R888 or Track tyres Anyone have anything?
-
Thanks Guys I'm running a set of wilwoods and the ball joint is fouling the disc. Been advised oe items Improve the situation, didn't really want it take an angle grinder to them
-
Hi Guys Does anyone have the part no for oe front ball joints? Thanks
-
Thanks for everyones help. Numerous small issues seem to have solved it. Running much cleaner now, and holding boost well. Thanks guys!
-
Will get the knock sensor re connected and see how it runs. Any suggestions on best place to get shielded wire from?
-
The wiring knock sensor wiring from the end of the injector loom down to the sensor has broken. Can anyone suggest type of wiring required and best place to get hold of it?
-
Slight Update. Have done a diagnostic check. Showing code 12 and 52. Battery has been very flat, and is still in need of a good charge. Also traced the knock sensor wire back and found a break in the wire. Whether both of those codes are enough to make it as laggy as it is I dont know, I guess it would explain the rough running though?
-
Penny has been welded. Will drop the down pipe off. Worth a check Ollie, it has a hks mushroom filter which im never a fan of. Will try with no filter
