speermint

Yesterday i fitted a new clutch and now it rattles when i go over 40mph. It sounds almost like creaky plastic. It dosent matter if im accelerateing or decelerating, fully speed dependant. Ive read it could be a wheel bearing but it sounds the same sort of noise as when my previous engine blew up.

Do people ever stop spending money on starlets? Or do they just declare bankruptcy and drive off into the sunset 😂

The temperature gauge keeps rising and falling, after fitting td04 all the wires are in tact could this just be the sensor on the way out?

The temperature gauge keeps rising and falling, after fitting td04 all the wires are in tact could this just be the sensor on the way out?

Will have to be a summer job as ill be up north for work, and dont know anyone up them ways to help me out

Someone has fully butchered my engine wireing loom think im just going to take it to an auto electrician

Nah cars exactly the same when the lights on :/

Probably havent been wiped since the previous engine though. Im assuming 34 is cause my intercoolers too small what you reckon?

12

42

34

Few morw codes than expected 😂

Bridge with a bit of wire yea?

When driving my car with a little more boot, the engine management light comes on then when i turn the vehicle off and on again it goes away again. Recently started doing it when i fitted a new intercooler, but cant see how this would cause the light. Any help appreciated! Thanks in advance

Yea i replaced the engine, but the boost controller has never been hooked up was just sitting there when i bought the car, guy said it boosted to much but the gauge said otherwise when i tried it just wondering if its worth it.. probably not

So i fitted a manual boost controller, but worried about over boosting.. the pressure appears to stay the same but the 3rd green light comes on alot sooner. Yay or nay? Dont want to have to put a 3rd engine in my glanza 👎 thanks

Cheers mate!👍

Im back this weekend mate but all my funds went on the new engine, but i will be in touch about that one buddy ;)

So safest bet is standalone? Thanks buddy!

Do you need a standalone/ plug and play to map a glanza or can you map the standard ecu?

Yea, i can pull the plug from the back of the clocks how would you go about plugging it back in?

So i put a new engine in my glanza and now my speedo has stopped working, rev counter still works fine though. Any ideas and help is appreciated 👍

Engines in! Speedo doesn't work anymore for some reason but its running a dream! Literally so happy with it.. thanks for all the help lads 👍

Bought an engine off him and all is well, thanks alot! Shes a honey, i will take care of her ;)

Thanks guys! Should be dropping it in tomorrow! Failing that next weekend 👌

How can you differentiate between the 4efte and the 4efe?

How can you differentiate between the 4efte and the 4efe?

Thanks guys appreciate it