starlet virgin

hi all bin thinking bout getting a oil catch can are they worth getting are they easy to fit and what is a good brand to go for many thanks all

hi looking at uprating my intercooler but dont wat to go front mount yet is the rx7 one a good fit and easy to do would love all your ideas and suggestions cheers all

hi there just remove my intercooler to get at my spark plugs pulled all 4 out how do u get the spark plugs out from there cheers

quick list

remove top mount intercooler if you still got one its got 4 mount bolts and 1 bonding wire and the 2 hose clamps.

then just pull leads out of the tubes and you will see the top of the plugs use plug socket to remove plugs.

re fit new plugs not too sure on torque figure was a wile since i fitted mine.

replace leads making sure they 'click' into place on top of the plug.

and re fit topmount replacing 4 mount bolts 1 bonding wire and both hose connections.

when your happy start her up making sure she runs smooth no missfire or excessive vibration and check there is no leaking around the re fitted hose connections.

and if all good, then good times!!

cheers mate thats great

hi got a 1996 glanza turbo and would like to no how to fit these spark plugs little guild would help cheers

hi have a 1996 glanza turbo would like to no how to fit these spark plugs cheers

looks like a nice clean standard starting block, what you got in the pipe line for it?

new seats not sure what ones yet

uprated discs and pads

manifold and decat

and a few more goodys

hi there here are a few pic of my glanza project just refurbed the wheel what do u think? look out as more mods to come

mods so far

blitz exhaust

gab suspension

speedline 15 alloys

baileys dumb valve

induction kit

have a 1996 glanza turbo what oil should i use cheers

hi all was wounding whos going to jap fest in castle coombe this year and was wondering how to get my car on this club if they do a stand cheers

Off with the bottom hose and let it all out, put a water hose in the top of the rad to flush out any gunk.....i`d replace the thermostat while your there cost £10-15, may aswell get a genuine one and saves hastle later on. Also which antifreeze are you using? best one would be toyota red its premixed

Good luck

cheers mate thats great

There's a drain plug on the bottom of the radiator so you don't nee to take the hose off, it just unscrews.

cheers for the help guys

hi wanting to change my coolant how easy is it to drop the coolant and change it cheers

undo it 100s then just tug at the wheel when its jaked up of corce with all the other ones out

cheers mate did that and it work the thread was mashed had to tap out the old on and replace it sorted

just got my self glanza turbo and was wondering if there was many round this area. im from chippenham

then it shouldn't really pop flames, the only reason i know of it fuel cut that's when the car goes over it's stock boost level around 0.85

and for safety reasons fuel cuts happens, this will result in a big jerk then sometimes a backfire or flames as there is unburnt fuel in the exhaust.

if you don't already get a boost gauge, then see what you are boosting at before it happens and report back.

thats sounds right im gonna invest in a boast controller and in the mean time will just drive softer cheers mate

do you get a jult before it happens could be fuel cut?

what is the spec on your car? it could only be popping flames if you are running rather rich

its a 1996 with bailys dump valve hks exhaust and indution kit running pretty stock

hi there been noticing that when im changing gear normally 3 to 4th if im giving it some speed on the gear change gives a really loud like pop bang and sometime a flame out the exhaust any one have a idea what is causing this and is it any think to worry about many thanks

like a cv joint sorta knock????? lol

if it is cv joint is this a hard to replace or expensive job let me no thanks

hi all removed all nuts of my wheel but one nut will not come off keeps spining so is loose but wil not come of resulting in me unable to take the wheel of any ideas many thanks

I'd say mor ethan likely CV joint but be careful cus i though that it turns out it is but its inner Cv so is munching chunks out of my box and generally not very nice

many thanks i wil see what i can do

hi my steering on my glanza 1996 knocks when turning right does any one have a idea what this could be many thanks