kdowg

ahhh do they i looked there before and cudnt find them ill have another look now cheers matey

anyone??

they ok and tht like matey? aye off a 4efte glanza engine i think there is slight differances from the gt and the glanza. i did buy sum off here but the new gingeon pin just rattled about inside the conrod and wasnt tight enough so im thinking the coonrods sum be wrong (i cud be wrong tho) and help with this would be appreciated cheers dan

was just wondering if any one knows where i can buy a conrod from cheers

anyone got any ideas haha

oem piston bought from cam skills and the rod is off a lad off here but there is too much play in the pin and rod wen assembled and pin simply falls out it has to be the wrong rod. thts y i was wondering of the dimensions of the glanza rod to so check it and find out if it thw wrong one cheers dan

i recently took the piston out of my engine as the ring land decided to give up. once i had the piston out i tried to remove the gudgeon pin from the piston but its completely stuck tried every thing. so i went and bought a conrod and went to fit my new piston and conrod together but the pin isnt tight on the rod and simply will fall out. so i was just wondering if any one had this problem before and can any one tell me the dimensions of a glanza conrod to see if i have the correct rod. ideally the overall length and the little end bore size cheers dan

mine done this when i had the shaft out and just ordered a new drive shaft seal and replaced it was only like a tenner or sumit from toyota

iamlegend for me like and tht is a very sexy blue glanza beside it hehe

any one kno any good products to remove oil from driveways i kno i wont get it all up but need sumit to clean and make it fade to stop the auld girl from moaning haha cheers dan

i have this problem between 3/4k and its still on a standard ecu bin like it since i bought the car last june driving me mad now like just fed up with it if im honest I've changed everything over and still noo joy. any of you lot find a cure will let me know so i can try it on my car cheers dan

ahhh cheers mate that would be a great help like all i want to do is swap mine over take it out and see if its the ecu thats causing the problem if not then im back to the drawing board lol when u free like matey ? cheers dan

not sure if this is in the right section but here it goes im having a problem with me car misfiring between 3/4k on the rev range, I've been asking people about it and afew have maybe a ecu fault so was just wondering if there is any one in this area tht i can borrow there ecu for like 5 mins while i check if it is the ecu and rule tht if the fault is still there. I've changed the whole ignition system and im seriously sick of spending money on parts and not solving the problem cheers dan

anyone ever had a problem with this as I've just put mine on and it popped off when i gave me car a little bit of a play :S

http://www.toyotagtturbo.com/forums/showth...ght=inlet+pipes there this explains all the pipe and tht plug looks like the knock sensor just under the inlet to me u got the map sensor and tht pluged up ??