Stevo_n

Going to sell mine soon, its a white glanza, 97, was a mess but sorted most of it.

ill try an upload a picture.

Spotted very nice.

Might be mine bud. ?

Hi, Do you still have the bonnet scoop? if so ill have it.

Steve

Right thats another one then, can see how that would mess with the fueling, so may renew that aswell.

Is the TPS a potentiometer?

Ok thanks, maybe a couple of sensors need renewing.

MAP sensor, allready changed Lamba, is there an Air temp sensor?

After the TPS ill be struggling. Had the Lamba up its back side, showing low fueling when its holding back.

Maybe a fuel pump issue haha theres a few to go at. Just strange how its fine on full throttle on boost.

Cheers ill see what results i get. Read somewhere else the car could have 2 Lamba sensors. Do you know if this is correct? Sure mine has one only.

Anyone know which type of TPS a EP91 Glanza V has?

Got a hesitation problem through the lower revs <3k part throttle is when its more apparent.

Rear strut brace still available?

YHPM

Item recieved in good time, as described. :-)

Thanks

Steve

What sort of revs do the ct9 turbos hit full boost (1bar) with simple breathing mods? Just a rough idea.

I bought mine with a td04 on, its late but seen as its a 1.3 with a bigger turbo than made for it isnt to bad. Also it has an 8 intercooler to fill.

Power wise?

Ct9. 170-190?

Td04. 200-220?

New to thease cars.

Steve

Nice example there.

What springs are fitted at the rear?

Steve

The bolts i have bought are the camber adjustment ones. They will be fitted Saturday, then tracked and set.

I will let you know what the results are.

Don't fancy bending the beam tbh. It will be fine as it is.

Don't know if you have seen the progress thread, but i carnt stay out of the car lol

May sound daft but i have passenger side only, if any one else only has one though it would sort it.

Let me know if you need it.

Steve

Been told its the perfect camber setting for road use matey

Yeah it will be fine at that, shame you can't set rear's though. Car has been tested and run for a few days, will update the progress thread soon.

have parcel shelf here UNCUT-clean... out of my glanza

YHPM

as far as im aware mate, just in need of a hoover

YHPM

I've adjusted my front to -1.5 degrees!

Going to do same, no more though, bolts arrived today so see how they go.

I have a carpet you can have for a fiver plus postage mate

What condition bud?

I have a bench alone here of you want it

YHPM

It was sent on Friday mate, should be there tomorrow if it hasn't arrived today.

Cheers

Idrees

ID-Workz

Cool, thanks bud

Steve

Garage received fogs last week, any news on bumper bud?

Steve

any idea of the rough dimensions and weight and ill get a quote

Not at the minute, get them after work

The rear is not adjustable it has been covered a few times all ready on hear if you have a look, the ends of the rear axle are welded into place so carnt be adjusted.

I had searched and found same results, just a last resort.

Thanks for reply

Steve

The bottom part bud? Yeah i can give you that postage will be £15 so make me an offer on bench

Aint a clue what to offer pal, whats condition? Any holes or tears?

Got a boot carpet

And have got a parcel shelf but postage will be mad :/

i had pm.d you bud, How bad would it be? Any idea?