Tyron Devine Posted July 12, 2011 Share Posted July 12, 2011 As above guys im takeing my engine out of my GT for rebuild where do i start lol ?? Quote Link to post Share on other sites
nazzurro19 Posted July 12, 2011 Share Posted July 12, 2011 under the bonnet Quote Link to post Share on other sites
Tyron Devine Posted July 12, 2011 Author Share Posted July 12, 2011 Jokerr ^ lol i no whats what under there just i dont no where to start :/ Quote Link to post Share on other sites
nazzurro19 Posted July 12, 2011 Share Posted July 12, 2011 when we did my mates scooby we started to take off all the ancilaries etc id start with all the fuel lines, pipes etc and connectors , get lots of pics and use masking tape to label connections will make it easier putin it all back Quote Link to post Share on other sites
Tyron Devine Posted July 12, 2011 Author Share Posted July 12, 2011 when we did my mates scooby we started to take off all the ancilaries etc id start with all the fuel lines, pipes etc and connectors , get lots of pics and use masking tape to label connections will make it easier putin it all backThanks bud i have already removed all wires connections Etc. I have been told its a easy job just i don't wanna fuck anything up :/ Quote Link to post Share on other sites
Tyron Devine Posted July 12, 2011 Author Share Posted July 12, 2011 Thanks mate Quote Link to post Share on other sites
Raz Posted July 12, 2011 Share Posted July 12, 2011 what did you do before painting it? Or did you leave it in there? I allways thought you took every single thing off the car Quote Link to post Share on other sites
LeeG Posted July 12, 2011 Share Posted July 12, 2011 remove rad, undo the bottom ball joint at each side (2bolts+1nut) to allow driveshafts out of hubs then remove them from gearbox, disconnect exhaust at bottom of cat and undo rubbers on centre section on exhaust tht'll allow enough room to get engine out, then remove bolt from rear gearbox mount then its just matter of either using crane to lift out or trolly jack under engine and strap round engine and lower it down and remove from underneith. (thats the way ive done it many times.) Quote Link to post Share on other sites
Tyron Devine Posted July 12, 2011 Author Share Posted July 12, 2011 what did you do before painting it? Or did you leave it in there? I allways thought you took every single thing off the cari Didn't repaint the engine bay 1 thing i left Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.