TurboTD04 Posted September 19, 2013 Share Posted September 19, 2013 Hello i am just about to start polybushing my engine mounts was just wondering what the best way is to get the old mounts out? have heard about burning them out is this the best way? Thanks Quote Link to post Share on other sites
Broony Posted September 19, 2013 Share Posted September 19, 2013 Easiest way is to get someone to press them out with a press if your doing it your self then burn them out as a cheap alternative. Quote Link to post Share on other sites
jezza Posted September 19, 2013 Share Posted September 19, 2013 Or if you get access to a reciprocating saw and be careful not to cut too deep! Quote Link to post Share on other sites
TurboTD04 Posted September 19, 2013 Author Share Posted September 19, 2013 Ok sweet thank you do have a press at work can use that I do like the idea of playing with fire though haha Quote Link to post Share on other sites
mikey4410 Posted September 19, 2013 Share Posted September 19, 2013 Burning em out is fun.then when rubbers out the way,hacksaw into the bush sleeve and then when thats cut it comes out with hammer and chisel. This method proved quickest by far.tryed and tested.lol Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.