Chief Quimby
-
Content Count
209 -
Joined
-
Last visited
Content Type
Profiles
Forums
Wiki
Media Demo
Store
Calendar
Posts posted by Chief Quimby
-
-
I ran 10/40.
No modifications roo oil gallery
Ran stock oilpressure.
But i had the biggest clearence allowed after specs.
-
I have had 3 5efte engines, with 250-412 hp. And know a few who run them too. Never had a fault on bearing.
You dont need upgrade pump, you need to run the right oil, and make sure clearence is right in bearings.
-
I did it on my old starlet 4efe, just using a mapconverter with bigger injectors.
Ran it for almost 2 years, had no problems.
-
there on egay
-
Remember to check clearence with plasticgauge
-
Nope, but i knew that i need to let the oil cool down sometimes.
-
I used the 6 speed from jap 20v in my 400hp 5E., never killed 3 gear.
Only time i tryed, was in old race car, after massive test and tune on road, the gearbox was very hot.
You need to cool oil down.
-
Only have this, this was 1,35 bar with the small 0,63 housing
http://www.bilgalleri.dk/album/storbilledevisning/45820-revnet_manifold?n=2297372
-
Was running 412hp at 2,1 bar with the small 0,63 exaust housing
-
I ran 2,3 bar on my 5Efte with a gt3071, stock ignition
-
Crazy price, hehe. But thanks
-
Where du you buy them ?, only toyota oem ?
-
Like Colin say, they properly come from the same place.
Have you ever heard a stel conrod break ?, i havent.
I have them in my 5e running over 400 hp, running them for almost 10000 miles.
-
Well, you can easy reuse oem, you just messure them, and make sure they havent stretch to much.
-
-
Easy to test, next time, just leave it for the night, next day, test if they have still the same touqhe
-
Yes, you do have to tighten it 2 times with mls, and yes, you can use stock bolts twice.
I did it in my 5e, running 412hp. I even reused the gasket and bolt after i bended 8 valves, still no problem.
-
Did you tighten it 2 times, i mean tighten, then wait 30 min, then losen , and then tighten it again.
Sorry about my english, hope you understand.
-
Make sure, they are the same weight
-
Wasted spark is not good, if you run high boost, an spec cams
-
Me ?, i use the bone stock ones from 4age at 2,3 bar.
-
I use standard plugs from 4age 16v, 0,6 gab on my 400hp 5efte
-
-
"and its a dead cert a rod will shoot out the block aswell.
Why ?, have you tested flatshit ?
Want to Forge but have some questions.
in Forged Series
Posted
Also make sure that they modify the rods, for better oilflow, and squirting oil.