MitchD

Wanted half rad,

preferably with fan and fitting kit.

thanks

mitch

Could be Intrested in 4a depends on condition and price ? And also whether there on ep91 rails

As per the title please message me

Hi All,

what manifolds do you reccomend for a standard ct9 that dont tend to crack as much?

thanks

mitch

Morning,

does anyone know where i can get the above from complete with the bearings? as most places just sell the discs?

also is it necessary to change the bearings?

thanks

mitch

Think I'll refit the standard one .

Also if i save the money for all my mods for stage 1 and then fit them all at once and then get it mapped will there be any need to Dremel the wastegate ??

Thanks

HI all,

i fitted a air filer relocation onto my glanza v ( relocated behind the grill), since doing this i have hit fuel cut 3 times peaking at 1 bar!, i have now stopped using the car until i can sort the issue.

on monday i wound the HKS actuator all the way out and reset the peak on my boose gauge to try it again now i hit fuel cut at slightly higher revs and the gauge peaked at around 0.9 bar.

now my suspicion is the actuator is on its last legs as it requires no efford to clip back into place and does not feel very 'springy'?

can anyone advise me as to what to do next?

change the actuator and if it doesnt work install a fcd and run at 0.9 bar?

please advise.

Mitch

BTT

I think my actuator has given up so I'm after another

Pm me

Thanks

Mitch

Hi all,

im looking for a tubular or ramhorn type manifold for a ct9 glanza v.

thanks

mitch

Hi All,

i have just bought a set of corbeau seats for my glanza and was wondering where to mount the side points for the harnesses?

i know where to put the 2 over the chest ones(eye bolt into original seatbelt holes for the back seats)

thanks in advance

Mitch

Bttt

btt

Btt ideally looking for a cusco type one

Hi All,

anyone know the thread pitch for wheel nuts?

M12x1.?

for a glanza v ep91

thanks in advance

Mitch

As per the title wanted rear strut brace for glanza V

please inbox me .

thanks

mitch