glanza ep91 23
-
Content Count
146 -
Joined
-
Last visited
Content Type
Profiles
Forums
Wiki
Media Demo
Store
Calendar
Everything posted by glanza ep91 23
-
I was looking at the online Toyota epc parts catalog and I am unable to find the wiring pins and rubber grommets for connectors pins and some of the connectors themselves. Is there part numbers available for these items or a website where I can source these parts? Thanks
-
Thanks
-
I am removing the steering column from an EP80 starlet and I am just wondering can the steering column be removed without taking out the dashboard ? If so how do i remove the column with the dash in place.Thanks
-
Ya there just a small bit of play in it when i fit the driveshaft and tighten the nut ill see thanks
-
hi i install a wheel bearing and the bearing split a few times is that normal? And ive installed the hub plate and there a small wobble is that ok?
-
What grease do i need to lube the front hub bearings with?
-
Hi i put in a new brake master cylinder and ive to swap the plug but i dno which wire to connect to the oem plug?
-
Hi i three bolts left do they just thread in or am i missing something
-
Ya tried that ended up taking the head of the bolt off now im wondering will i cut the dust plate at the lines drawn or leave it off
-
Basicaly i cant get the bolt out its spinning. So will i cut the dust plate along the lines or will i just run without it
-
Hi i broke the 10mil bolt that hold on the dust plate and now im wondering can u run a manual without one thanks
-
Ya i know the dizzy one its the one that snapped off im not too sure of
-
-
-
Hi im wondering what is this plug for and also where can i get a replacement thanks
-
i stripped and redid my loom because it was fucked before etc and it all finished but i fucked up and forgot the horn wiring ive the 2 wires going into the oem fuse green one and white but now i just think it be easier if i just rewired my horn seperatly so im looking for advice on how todo it and materials etc
-
ya ill try the weld option hopefully it works
-
One of the bolts attaching my front anti roll bar snapped off and im wondering whats the best way to remove it
-
Thanks
-
Do the chassis bars attaching to the engine mount on top of the plate and bolt in or under like in the picture?
-
thanks
-
hi im just checking are these lines connected right?
-
hi i just wondering on a glanza does anyone know the Throttle position point for open loop transition (%) thanks
-
Mickl modified hill climb build
glanza ep91 23 replied to MickL's topic in EP91 Glanza Progress Blogs
what mm metal did u use to reinforce the firewall? -
The disk and carries are fine because it fit the otherside perfect it just that one side where it rubs hence y i think it could be the bearing