glanza ep91 23

I was looking at the online Toyota epc parts catalog and I am unable to find the wiring pins and rubber grommets for connectors pins and some of the connectors themselves. Is there part numbers available for these items or a website where I can source these parts? Thanks

Thanks

 I am removing the steering column from an EP80 starlet and I am just wondering can the steering column be removed without taking out the dashboard ?  If so how do i remove the column with the dash in place.Thanks 

Ya there just a small bit of play in it when i fit the driveshaft and tighten the nut ill see thanks

hi i install a wheel bearing and the bearing split a few times is that normal? And ive installed the hub plate and there a small wobble is that ok?

What grease do i need to lube the front hub bearings with?

Hi i put in a new brake master cylinder and ive to swap the plug but i dno which wire to connect to the oem plug?

Hi i three bolts left do they just thread in or am i missing something

Ya tried that ended up taking the head of the bolt off now im wondering will i cut the dust plate at the lines drawn or leave it off

Basicaly i cant get the bolt out its spinning. So will i cut the dust plate along the lines or will i just run without it

Hi i broke the 10mil bolt that hold on the dust plate and now im wondering can u run a manual without one thanks

Ya i know the dizzy one its the one that snapped off im not too sure of

Hi im wondering what is this plug for and also where can i get a replacement thanks

i stripped and redid my loom because it was fucked before etc and it all finished but i fucked up and forgot the horn wiring ive the 2 wires going into the oem fuse green one and white but now i just think it be easier if i just rewired my horn seperatly so im looking for advice on how todo it and materials etc

ya ill try the weld option hopefully it works

One of the bolts attaching my front anti roll bar snapped off and im wondering whats the best way to remove it

Thanks

Do the chassis bars attaching to the engine mount on top of the plate and bolt in or under like in the picture?

thanks

hi im just checking are these lines connected right?

hi i just wondering on a glanza does anyone know the Throttle position point for open loop transition (%) thanks

what mm metal did u use to reinforce the firewall?

The disk and carries are fine because it fit the otherside perfect it just that one side where it rubs hence y i think it could be the bearing