1990timeismoney

Hi all looking for the part number or a set of bonnet gas struts.if I remember there was a group buy many years ago looking to see if there's any around to buy or part number and length of strut I will make the brackets if needs be. Thank you Luke

Hi all.on the lookout for a passenger window motor for a gt or ep91 if anyone has one in storage. Thank Luke

Hi guys Having a few running issues with my EP82 Seems to fuel fine when cold. And idle fine. But as soon as it gets warm it bogs down when tried to be driven.also a very flat spot when stepping on gas. One think I've noticed is that when it's warm if I remove a vacuum line the car goes from running lean to running better afr. If anyone's had similar troubles like this any help would be greatly appreciated. Thank you Luke

Hi All. Looking to buy a ep82 engine/ecu loom.over time wires have deteriorated and connectors broken so looking for a full replacement if any members have one around. Thank you Luke

Made a few test panels out of acrylic with the ability for custom engraving.made from 3mm acrylic and some 1.2mm think carbon fibre panels.

Made a few test panels for ep82 out of 3mm acrylic will be doing custom designs. And one carbon fibre. Just fitment to trial now.

For sale: under seat storage tray Item Condition: well used condition. Price and price conditions: £80 plus +£8 delivery charge. Extra Info: never had the runners for the tray so unfortunately these won't be available its just the tray on its own. Pictures: Contact Details pm. Location: Isle of wight Delivery & Conditions of Delivery: £8 delivery Royal mail

Hi Recently changed from wastegate to external wastegate and have a blitz dual sbc is there any one with one installed or have information on where each port goes to. Thanks Luke

Hi all Looking to buy an 38mm external wastegate with spring to run 1 bar of boost fitted. Thank you Luke

Hi all Looking to buy a complete rear drivers side brake caliper . Good and fully working condition. Thanks Luke

hi all. Looking to buy seat belt for passengers side ep82. Luke

Ignition light gumtree may still be available. https://www.gumtree.com/p/car-replacement-parts/toyota-starlet-glanza-v-turbo-ignition-barrel-light-rare-jdm-option-/1370264526

Hi all. Currently looking for a drivers side headlamp as mine has cracked.anyone with one for sale would be much appreciated. Luke

Sold

For sale my zisco inlet manifold with the extended 5E throttle cable. In good condition. £150+12.50 postage plus PayPal fees

I'll be in to sounds good

Bump

That's a good point.as above I started to drill and tap for holes to use fasteners like washer spring washer with some high strength stud loctite.i to worry about losing a screw but I hope it holds if not it's of to the welders.and rebuilders. I appreciate your reply and advice.will update with pics once complete.

That's a good option thank u for the advice.

Ok that's great thank you for the advice I'll get it all cleaned up and look into getting it either bolted or tacked.

Thank you for the reply.ill go with your recommendation and I'll get it drilled and tapped and get some loctite

Hi guys had my rocker cover welded with AN- fittings at the time had the baffle removed to make sure it was all clean underneath.do you need the baffle re installed or will it be ok without it.

Hi thank you for they reply.will be running blitz ECU and a td04 or the TF035 turbo. intercooler fpr etc its currently running 1bar with the td04 on standard wastegate

Hi all.looking to buy a 38mm wastegate for my turbo setup.along with any advice on the correct spring to run 1bar. Thanks luke