TRD-1

Hi Guys,

Need the following parts for my conversion, if anyone has any of these give me a shout.

Cat support bracket

Stock CT9 Hot pipe

Air Con compressor bracket

Thanks

PM sent

Hi Guys,

I need some parts for a conversion, if anyone has any of the following give me a shout please, doesn't matter if there from a EP82 or EP91 but must be from the 4EFTE.

1. Cat support bracket (the one that bolts to the cat and the block)

2. Wiring plugs, if anyone has a damaged engine wiring loom I need the following plugs: Distributor, Ignitor, Coil, Idle control valve, TPS sensor

3. Stock fuel pressure regulator

Thanks

Its a non ABS model, I made sure the surface was clean as possible when I installed them, I cleaned all the old grease off the rear's and re-greased the new bearings etc. The fronts seem fine, I think the problem is with the rears as fronts seem to be ok and there is no steering vibration etc.

Ive opened up the brakes several times to see if I can locate anything, Ive cleaned up the guide pins, lubed the boots, lubed the carrier, not sure what else it could be if not a warped disc. I was sent blueprint discs so wasn't so certain that they would be warped!

However the first time I noticed this was when I had my tyres changed they used a air gun to replace the wheel nuts not sure if that has warped the disc, or if Ive not seated the bearings properly.

Its surely confusing.

Hi guys,

Ive got a problem with my brakes, Ive replaced everything with new discs and pads all round, done the rear bearings to, but upon refitting I keep getting a pulsing feel in the pedal, not sure what it is, I have checked over everything to the point of removing everything and refitting it all again, but nothing has changed, could this be a rear caliper problem?

My car is a EP82 1995 completely stock, car was stood around for about a year or longer before I brought it, I done everything it needed for MOT, but can't resolve this problem, not sure if I was sold warped discs. I brought everything from camskill.

Any help and advise is appreciated, as Im hoping to get back at them this weekend.....TIA

Personally I would garage it without stripping anything off yet, just make sure u don't mention it to anyone where it is, wait for the outcome from the police, if they want it back, just spend a few days stripping it, and tell them u will give it back in the same condition u brought it in, I would personally strip everything off it, sell everything and just give them back a bare shell with the correct chassis number there looking for!

Its a bit pants when something like this happens, but u have to get your hard earnt money and time out of it.

Thanks for the welcome guys, Im from near bluewaters. I brought the EP82 through ebay, it was for sale a while back with no tax or mot. I got it home and on axle stands and it needs bascially service items, brakes, cv gaitors, and its got a annoying blow on the manifold which has been changed for a stainless one, I was given the stock one with it, so Im contemplating getting all new Toyota gaskets and replacing that back on to see if it cures it.

Apart from that I was hoping after a bit of saving up to tune it a little, nothing major just have a modest figure in mind.

Hi Guys,

Ive just brought myself a EP82 GT before christmas, needs quite a bit doin to it, to get it through the MOT, but im just making a list up and working through it slowly.

Hope to get to know some local members.