4efteboost

yeah weekend is cool man cheers, managed to bodge my non abs expansion tank in over by the battery but is covering the hole where the abs versions washer bottle neck pops up through the body work so need to see if a glanza expansion tank will fit

Is it cool of you could pm me a pic of the bottle please? And yeah was thinking the same with the wiring and extending it back through the conduit

is that a pipercross filter? Ive got a blitz and its way too big to fit down there

Jamie thats the manifold i got off you, struggling to make anything fit with the powersteering in the way lol How was it getting a decent airflow to it there? Have seen that it can make a bit of difference when getting mapped if the filter is stuck behind the headlight

got a question for the boys with their filter behind the headlight. Does enough cold airflow get to the filter with it being there? Im in the process of putting my top mount kit on and think im gonna have to put the filter there aswell but worried about not getting a decent amount of cold air

Has anyone on here gone and put a glanza washer bottle and expansion tank in an ep82?

Have got a top mount manifold and need the room for a filter on drivers side. Have read the glanza bottles are the same as an abs equipped ep82 but still not sure. And if you have how did you go about moving the plug for the washer pump over to the otherside of the engine bay

Have you got the standard glanza windscreen washer bottle and radiator expansion tank? Also have you got a pic of your oil return for the top mount kit?

Need these please for as cheap as possible!! Gone top mount on my ep82 and no room for filter 😭 lol

Sorry should of put that i found one elsewhere but thanks anyways

Need one thats not smokey ASAP!!

http://www.toyotagtturbo.com/wiki/EP82wiring/EP82%20Starlet%20Wiring%20and%20Connectors.pdf

If you take a look at that link and scroll down a few pages you will see pics of plugs and its number 55

Has anyone got an old loom they could cut the igniter plug off with a couple inches of wiring? Somehow my blank plug on the intercooler pipework flew off and completely ruined the plug/wiring

SOLD!!

Bumpooo

Bumppppoooooo

Bump

Bump

Bump

??

Bump

with it setup like that you have all the pressure going to that catch can but its got nowhere to go so its just going back and pushing past the oil cap

with that type of catch can you need to have both pipes from rocker cover to go to the same inlet on the can by using a t piece and on the outlet have a bit of pipe pointing to the floor with maybe a little filter on it so that way its letting the pressure get out

To test it you should disconnect one of the braided lines to the catch can and run the car, if it runs better then you know thats the problem

Bump

In need of a 2 plug ep82 extension harness so i can wire in my emb

Anyone got one knocking about?

Bump

Bump