-
Content Count
2791 -
Joined
-
Last visited
Content Type
Profiles
Forums
Wiki
Media Demo
Store
Calendar
Posts posted by dangeestarlet
-
-
Tongs the best and won't fit with efi pipe as the tongs has a larger diameter inlet
-
They must both have logbooks surely?
-
Perhaps its rich dogs that's a ringer
-
But what about the vin plate , the square one riveted on
-
Burny off here that lives by me just sold his 13k
-
-
Just finished my turbo conversion and getting it ready for mot , when I press brakes the dash lights light up and also if the ignition is off and I turn sidelights on I have no dash lights but as soon as I turn ignition on they light up, I know that they should light up with lights on even tho ignition is off because all my other eps did , thanks in advance
-
I sit just me or does that rear drivers arch loom mashed?
-
Take £20 for gt seats ?
-
Starter ignition feed I'd say
Il check on my car for you tommorow
-
Bottom yellow is oil pressure one as its a spade that slides on a round thing on the sensor , it's locsted on front right hand side of engine on the block
-
Sure the yellow one is the oil pressure one? And the grey 2 prong one the reverse light one?
-
I have a complete silver bootlid , in South wales
-
As above want a n/a close to South Wales or be willing to post thanks
-
-
I got a set of like new just a few months old tein lowering springs on same age kyb shocks , £120 , cost nearly £450 new
-
Anyone know if I can use a gasket off any car which is the same as the cat to exhaust gasket on a 4efte the triangle 3 bolt one. Need one off the shelf in a local motor factors on weekend if possible thanks any other uk toyotas fit? Thanks
-
Just done a conversion and it will start then run for like 30 seconds then cut out and when turning over sometimes it will go to fire then sometimes it won't , any help great thanks
-
Just done a conversion on my sr and put full glanza loom clocks etc , no ignition lights , heaters , de mister etc , any help would be great thanks
-
I got one bud
-
I feel for you dude , I got a passenger mint 1a0 silver wing free for you but I'm in South Wales
-
Ok thanks very much
-
Doing a conversion and using a glanza box and was wondering if I can use my n/a shafts on the glanza box till I get a set of glanza shafts and if not can I run my n/a box on fte clutch and flywheel
-
Got a mint 4efe one?
Anyone know history on this MK1?
in Lifestyle General
Posted · Edited by dangeestarlet
hmmm