mr_K Posted December 2, 2018 Posted December 2, 2018 I have a hks evc v on my glanza and everytime i tried to plumb in the vacuum hoses and set the controller up its overboosting and not holding boost, im doing something wrong but i dont know where; i followed the hks manual but still no luck. my setup is running a external wastegate can anybody help me on where the boost solenoid hoses go to.? Quote
RobSR Posted December 3, 2018 Posted December 3, 2018 Can you post a pic of how you have it plumbed currently? I can then advise if correct / wrong. Quote
mr_K Posted December 5, 2018 Author Posted December 5, 2018 On 12/3/2018 at 5:22 PM, RobSR said: Can you post a pic of how you have it plumbed currently? I can then advise if correct / wrong. Ive plumbed it in the same way as stated on the installation guide, the port which draws air in from intake is connected to the throttle body, is that correct? Or is it ment to be tapped into the map sensor hose? Quote
RobSR Posted December 5, 2018 Posted December 5, 2018 Which nipple on the throttle body have you used? Quote
mr_K Posted December 5, 2018 Author Posted December 5, 2018 7 hours ago, RobSR said: Which nipple on the throttle body have you used? This one Quote
RobSR Posted December 6, 2018 Posted December 6, 2018 I think thats what will be causing you problems. Move it to one past the throttle plate on the inlet manifold. There is one on the front that the original bov used. Try it there. Quote
maerijn Posted December 6, 2018 Posted December 6, 2018 Don't split the map sensor hose, use the nipple which is closer to the idle control valve Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.