gwtaylor Posted March 15, 2019 Share Posted March 15, 2019 Should the front anti rollbar be this close? Quote Link to post Share on other sites
rob_bower Posted March 17, 2019 Share Posted March 17, 2019 seen a few people have this problem with thick arb’s hitting lower arm mounts I had some spacers made which I might have somewhere. But those droplinks need tightening up. Quote Link to post Share on other sites
gwtaylor Posted March 17, 2019 Author Share Posted March 17, 2019 1 hour ago, rob_bower said: seen a few people have this problem with thick arb’s hitting lower arm mounts I had some spacers made which I might have somewhere. But those droplinks need tightening up. Cheered rob I didn’t even notice they needed tightening as I bought it as a project best get it checked and go tighten every bolt wherr would the spacers go? Quote Link to post Share on other sites
rob_bower Posted March 17, 2019 Share Posted March 17, 2019 Yea the droplinks definitely wants tightening up. I’d also check that lower alk bush as there shouldn’t be that much of a gap. The spacer sits under the arb to chassis mount to drop it down the same amount as the alk plate. Quote Link to post Share on other sites
Di_Bodi Posted March 19, 2019 Share Posted March 19, 2019 Here it is my thicker TRD one - tight but never knocked Should have it painted before fitting!! I have the spacer plates made up and fitted at the same time when fitting anti-lift kit. No knocking luckily! and the TRD bar still not painted...:(( laziness! at least it's undersealed now Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.