McGlinchey Posted August 14, 2012 Share Posted August 14, 2012 As above, when fitting my anti lift kit on my glanza I've seem to have broke the threaded bit inside the chassis were the alk fits to the car.. Drivers side screwed in no problem , it's just one bolt on the passenger side.. Wtf can I do from here?Thanks in advance Quote Link to post Share on other sites
akyakapotter Posted August 14, 2012 Share Posted August 14, 2012 drill and re-tap Quote Link to post Share on other sites
shorty Posted August 14, 2012 Share Posted August 14, 2012 Scrap the car and start again Or just get a thread specialist to remove it and clean the thread up ;) cost about 30-50quid is the norm. bolloxs to drilling and tapping yourself unless your awesome with a drill you will just make a mess. get the guys who do it day in day out Quote Link to post Share on other sites
McGlinchey Posted August 14, 2012 Author Share Posted August 14, 2012 Seen on a another site about cutting a hole in the floor to get at the nut which sounds a bit drastic . Anyway thanks for the info lads Quote Link to post Share on other sites
klyfax Posted August 14, 2012 Share Posted August 14, 2012 Drill it and give it an oversize tread. You can get coils that goes from one tread and one down. From 10 mm to 8 mm or from 12 to 10. Or bigger, or smaller. Quote Link to post Share on other sites
Ryan-11 Posted August 14, 2012 Share Posted August 14, 2012 (edited) The way i read that is you've snapped the captive nut inside the chassis? and not snapped the bolt? You'll find it hard to drill and tap it if its snapped off and is stuck inside the chassis, the only way is to cut it out and weld in a new nut and weld the bit back in. Edited August 14, 2012 by Ryan-11 Quote Link to post Share on other sites
McGlinchey Posted August 14, 2012 Author Share Posted August 14, 2012 The way i read that is you've snapped the captive nut inside the chassis? and not snapped the bolt? You'll find it hard to drill and tap it if its snapped off and is stuck inside the chassis, the only way is to cut it out and weld in a new nut and weld the bit back in.Yes that's what's happened!! Has this happened to anyone before? Quote Link to post Share on other sites
akyakapotter Posted August 14, 2012 Share Posted August 14, 2012 ah in that case its cut and weld job Quote Link to post Share on other sites
shorty Posted August 14, 2012 Share Posted August 14, 2012 As above. makes sense now lol. if its a captive nut you have very limited options Quote Link to post Share on other sites
McGlinchey Posted August 14, 2012 Author Share Posted August 14, 2012 Fuckkk!! Oh well shit happens.. Thanks anyway lads Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.