Taggy Posted August 17, 2012 Share Posted August 17, 2012 Since putting my new manifold decat on, it doesnt line up properly with my custom full exhaust system to the decat pipe, its lined up ok in terms of being straight, but the pipe points up too much and you cant quite fit it. I need to bend the pipe down slightly by the flexi pipe to get it to fit.The full system comes off easy enough, anyone got any suggestions for bending it slightly without kinking the pipe? Trying to save my self some money and getting it to fit my self, rather than lugging it back down the exhaust place. Quote Link to post Share on other sites
Socks Posted August 17, 2012 Share Posted August 17, 2012 Get some mad heat into it and a proper pipe bender.. Quote Link to post Share on other sites
StuDoc 72 Posted August 17, 2012 Share Posted August 17, 2012 If you take it off yourself and go to a garage to have it bent only slightly it should literally take them 30 secs and they would have a cheek to charge you. We used to do this at my old work and never charged folk unless it was a bit more work but for 1 small bend i couldnt see any real bill Quote Link to post Share on other sites
Taggy Posted August 17, 2012 Author Share Posted August 17, 2012 sorted Quote Link to post Share on other sites
shorty Posted August 17, 2012 Share Posted August 17, 2012 Next time pack the pipe full off sand ;) can bend it then yourself with no kinks. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.