nathboii Posted April 30, 2013 Share Posted April 30, 2013 i bought a glanza engine or my ep82 and out it in I've done all the wiring and there are 3 wires that have no place to go. Anyway I put everything else on and it starts up over revs a bit and when you go to the boost the boost sits a -2 psi and then goes to 4 psi and starts like choking like a misfiring noise. It also says it's over heating aswell. can anyone help cheers nath Quote Link to post Share on other sites
AdamB Posted May 1, 2013 Share Posted May 1, 2013 Check the thermostat area for any loose/broken wires. This is one area where sensors differ between the two engines. Quote Link to post Share on other sites
daniel_g Posted May 1, 2013 Share Posted May 1, 2013 Yeah you'll need to use GT thermo housing on the Glanza FTE.I put a 98 spec V engine in mine and thats all thats different. Quote Link to post Share on other sites
nathboii Posted May 1, 2013 Author Share Posted May 1, 2013 cheers for that boys. right another problem I've put what was on my engine onto this engine it now ticks over at -6 boost and rev at 0.4 boost it feels like its struggling to get fuel but has set up just like the old engine. I've been told to get the timing change nod get a gauge on fuel pressure regulator. any suggestions on why it may be need as much help as possible cheers Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.