Ollieh17 Posted March 17, 2014 Share Posted March 17, 2014 Got the abs ring off my old driveshaft to use on my new shaft with No ABS, however struggling to get it to fit. Any ideas? Quote Link to post Share on other sites
malinheadman Posted March 17, 2014 Share Posted March 17, 2014 i have done this a few times you need to heat the ring with a blow torch or something the same and then get it into with pliers and go around it gently tapping it with the hammer the whole way around and it should go in to place with not much bother Quote Link to post Share on other sites
Ollieh17 Posted March 17, 2014 Author Share Posted March 17, 2014 issue i had was everytime i hit it in one place it pop off the other side Quote Link to post Share on other sites
malinheadman Posted March 17, 2014 Share Posted March 17, 2014 if you have anybody there get them to hold a hammer on one side and then you start tapping it from there make sure its gently taps and make sure you give it a good heating Quote Link to post Share on other sites
Ollieh17 Posted March 17, 2014 Author Share Posted March 17, 2014 sweet, cheers bud Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.