Stefan_s Posted September 12, 2014 Share Posted September 12, 2014 hi, i bought an avcr off ebay and all the wires have been chopped and its using a non apexi map sensor but have no idea what colour wires are for the map sensor on the actual avcr, would anyone with one that would be able to have a look for me and let me know thanks Quote Link to post Share on other sites
aaddzz123 Posted September 12, 2014 Share Posted September 12, 2014 I did a guide for this. GIve me a sec Quote Link to post Share on other sites
aaddzz123 Posted September 12, 2014 Share Posted September 12, 2014 http://www.ukstarletowners.com/topic/60485-a-guide-to-fitting-and-setting-up-the-apexi-avc-r/The solenoid uses a pink and red wire on one side and a pink and black on the other. The pink goes to the pink and the red goes to the black.The sensor wires are: Yellow - Red, Brown - Black and Blue white.All other wires are explained in the guide.Hope this helps mate Quote Link to post Share on other sites
Stefan_s Posted September 12, 2014 Author Share Posted September 12, 2014 thats perfect mate much appreciated, will give it a bash tomorrow, i got everything else wired up and after a drive the rpms are well out compared to my rev counter, could i have connected it to the wrong rpm connection on the ecu? Quote Link to post Share on other sites
aaddzz123 Posted September 12, 2014 Share Posted September 12, 2014 I had the same problem when I first installed it. It's because it will be set up as a 6 cylinder engine. You need to go into the settings and change it to a 4 cylinder. I think it's under "ETC" or something, I can't remember to be exact. Quote Link to post Share on other sites
Stefan_s Posted September 12, 2014 Author Share Posted September 12, 2014 ah that would make sense now as it was removed from a skyline Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.