Glanzacoley Posted October 13, 2014 Share Posted October 13, 2014 I've rebuilt my engine only thing I haven't changed is the oil pressure switch I bought one from I'd workz but it doesn't seem to fit :/ is it imperative that I change it guys? Quote Link to post Share on other sites
patman Posted October 13, 2014 Share Posted October 13, 2014 Did you do everything right mate? All clearances etc new oil pump etc Quote Link to post Share on other sites
Glanzacoley Posted October 13, 2014 Author Share Posted October 13, 2014 Yes mate engine builder done it but the oil pressure switch won't fit so old one is still in for moment engine will be done Wednesday possibly Quote Link to post Share on other sites
patman Posted October 13, 2014 Share Posted October 13, 2014 I got my oil pressure switch from id workz it's tight on but it doesn't go all the way in on the thread so if that's what you have then someone needs to quote us if this is right or not as my engines in a middle of a rebuild aswell 👍 Quote Link to post Share on other sites
Glanzacoley Posted October 13, 2014 Author Share Posted October 13, 2014 Ok mate haha I'll try get it on thanks Quote Link to post Share on other sites
patman Posted October 13, 2014 Share Posted October 13, 2014 Does it actually screw in at all mate? Quote Link to post Share on other sites
5e colin Posted October 14, 2014 Share Posted October 14, 2014 you can reuse the old 1 take it appart and clean it then fit a small washer in it to raise the oil pressure a bit works well Quote Link to post Share on other sites
patman Posted October 27, 2014 Share Posted October 27, 2014 Back to this subject just out of curiousity is the oil pressure switch suppose to go right in screwed tight so the switch itself is tight up against the block? As mine doesn't do that it's on tight but there's still a gap there 👍 Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.