Catch can setup help

[kevmcc90]

I understand that from the two fittings on rocker cover go to a vented catch tank, and that the port on the inlet needs blocked off, I'm looking to see what others have done to block this off?

[kevmcc90]

Bump

[5T4R7ET N/A]

Just have a look at other people engine bays that have catch can setups

I used silicone blanking caps,

Pick a size and colour and order from ebay

[kevmcc90]

Cheers mate

[kevmcc90]

Also does anyone know of anywhere that supplies ready made up braided lines or did everyone just make their own?

[5T4R7ET N/A]

I think most people get their own fittings and make own lines.

Best way to do it really, because you don't know how long the lines need to be, everybody has there catch cans in different places

[Whitenoize]

Also does anyone know of anywhere that supplies ready made up braided lines or did everyone just make their own?

can get the fittings on ebay go for good onesand not just the cheapest ones I made that mistake and the fittings leaked had to buy better quality ones Edited February 22, 2015 by Whitenoize

[The Toffinator]

Catch cans are setup in various ways, most people just run 2 breathers to a can and block off the inlet port, However this isnt ideal as the PCV Wont work correctly as it hasnt got a vacumm pulled on it. Best way is to run 2 breathers to a tank, Then a 3rd line running to the inlet so it still has a vacuum pulled on it to remove the gases.

There is a link somewhere with a diagram of a proper setup but im not sure where it is!