Andy32 Posted March 11, 2015 Share Posted March 11, 2015 looking for some advise,just fitted an rx7 intercooler and have been told can run up to 1 bar on a standard setup.also had turbo overhauled and ported by Liam. Excellent job and well recommended!!!so looking at best way to do this,manual boost valve or adjustable actuator?? have a fcd on car but have it on 14 as have heard some bad things about them.Andrew. Quote Link to post Share on other sites
Gainzy Posted March 11, 2015 Share Posted March 11, 2015 I would say HKS actuator @ 0.7 bar until you get either a plug n play or custom mapped ditch the fcd imo Quote Link to post Share on other sites
Andy32 Posted March 11, 2015 Author Share Posted March 11, 2015 cool think i'll start looking out for one.thanks mate! Quote Link to post Share on other sites
Gainzy Posted March 12, 2015 Share Posted March 12, 2015 You need a T piece if your not buying new if you need extra pipe's the a 4mm inner diameter off ebay I would buy new can't go wrong then. Quote Link to post Share on other sites
Andy32 Posted March 14, 2015 Author Share Posted March 14, 2015 Is the adjustment measured to the end of the rod or to thr middle of the eye where it sits on the actuator?thanks. Quote Link to post Share on other sites
WallaceGlanza Posted March 14, 2015 Share Posted March 14, 2015 You need a T piece if your not buying new if you need extra pipe's the a 4mm inner diameter off ebay I would buy new can't go wrong then. You don't need a t piece if you just want to run the one boost level. Quote Link to post Share on other sites
Andy32 Posted March 15, 2015 Author Share Posted March 15, 2015 So to be able to use the low boost option on the dash i have to t piece the actuator pipe and just link it in? Just bought an HKS actuator. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.