actuator or boost valve??

[Andy32]

looking for some advise,just fitted an rx7 intercooler and have been told can run up to 1 bar on a standard setup.

also had turbo overhauled and ported by Liam. Excellent job and well recommended!!!

so looking at best way to do this,manual boost valve or adjustable actuator?? have a fcd on car but have it on 14 as have heard some bad things about them.

Andrew.

[Gainzy]

I would say HKS actuator @ 0.7 bar until you get either a plug n play or custom mapped ditch the fcd imo

[Gainzy]

[Andy32]

cool think i'll start looking out for one.

thanks mate!

[Gainzy]

You need a T piece if your not buying new if you need extra pipe's the a 4mm inner diameter off ebay I would buy new can't go wrong then.

[Andy32]

Is the adjustment measured to the end of the rod or to thr middle of the eye where it sits on the actuator?

thanks.

[WallaceGlanza]

You need a T piece if your not buying new if you need extra pipe's the a 4mm inner diameter off ebay I would buy new can't go wrong then.

You don't need a t piece if you just want to run the one boost level.

[Andy32]

So to be able to use the low boost option on the dash i have to t piece the actuator pipe and just link it in? Just bought an HKS actuator.