ChrisLeeBoost Posted November 14, 2015 Share Posted November 14, 2015 Lads bought a braided oil feed for the td04 and block end was way too small for the banjo bolt that is in there, any idea what size end is needed for it? Quote Link to post Share on other sites
5e colin Posted November 15, 2015 Share Posted November 15, 2015 m14 mate on the engine side m10 size on the tuby Quote Link to post Share on other sites
ChrisLeeBoost Posted November 15, 2015 Author Share Posted November 15, 2015 Thanks mate can't seem to find one with 10 one side and 14 the other though any ideas where I would pick one up? Badly stuck for it only thing I need to get her going Quote Link to post Share on other sites
5e colin Posted November 15, 2015 Share Posted November 15, 2015 go to your local engineers that does hydrolic hoses they make you 1 on the spot fro 30/40euro max they have the banjos there then Quote Link to post Share on other sites
ChrisLeeBoost Posted November 16, 2015 Author Share Posted November 16, 2015 There's no shop like that near to me but I ordered one off racetech earlier should be here during the week Quote Link to post Share on other sites
funny onion Posted November 16, 2015 Share Posted November 16, 2015 Google pirtek, i'm not sure if they trade over in ireland though. I got mine made up by them, i went for 30mm length and its plenty for most set ups, i've now gone top mount and it's perfect for that just the right length. Quote Link to post Share on other sites
5e colin Posted November 16, 2015 Share Posted November 16, 2015 (edited) got this made up today for 18euros in my local hose place Edited November 16, 2015 by 5e colin Quote Link to post Share on other sites
ChrisLeeBoost Posted November 16, 2015 Author Share Posted November 16, 2015 Sickened I paid 40 quid for one from racetech Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.