00joeindastarb0 Posted December 5, 2015 Posted December 5, 2015 In the process of attempting an overhaul on my drivetrain but I'm struggling to remove the near side driveshaft. I went and bought a hammer, and then I bought a bigger hammer but to no avail.Is it going to be a replacement hub or does anyone have any suggestion to remove it without going down that route. Quote
Johnboy GT Posted December 5, 2015 Posted December 5, 2015 Do you have a big puller mate? I normally use an aluminium punch and a hammer if it is tight. They shouldn't be excessively tight though. John Quote
00joeindastarb0 Posted December 5, 2015 Author Posted December 5, 2015 I don't have a puller, but I recon it will probably break it. I've been hammering on it with a 2 and 4 pound lump, there's no movement. Quote
Ep82gi Posted December 5, 2015 Posted December 5, 2015 Seen this a few times lol. Normally caused by the retaining clips on the inside. Put the drive shaft in a vice with the cv joint you want to remove facing the floor pull down gently on the cv joint just to remove the slack ( in out movement) then a few swift hits with a fair sized hammer. Average club hammers my choice. Make sure you tap it down evenly around it so it comes off straight. That's how to get them off but I'm not going to lie and say there's an easy way because there's not. Quote
Ep82gi Posted December 5, 2015 Posted December 5, 2015 P.s getting them back on is the really fun bit Quote
00joeindastarb0 Posted December 5, 2015 Author Posted December 5, 2015 Ep82gi could this be the problem the other side came out after a good hammering is there a retaining clip on the shaft for the hub? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.