Chrishoughton1989
-
Content Count
304 -
Joined
-
Last visited
Content Type
Profiles
Forums
Wiki
Media Demo
Store
Calendar
Posts posted by Chrishoughton1989
-
-
Didn't do this. Will it harm it ?
-
Would I have taken it out ? Where is it ?
-
What can this be?
-
Think u have done more work on this car then I have and your not even hear lol.
-
Bridge the same ports as to do timing ?
-
Do I need to set throttle position first ? Or doesn't it matter ?
-
What then once timing set remove paper clip ? Or just connect up and remove straight away? Also does a light come on to say its in diginistic mode?
-
Can you explain more please on bridging ports ?
-
Good good. And the tensioner seems to tension it for you? Looking through the tiny hole in plastic lol. Just let it tension then nip bolt up ?
-
Also does it matter about oil pump position ? Some people mention that about timing it up ?
-
When timing ep91 4efte do you time it up to the 0 mark on the plastic cam belt cover and then do ignition timing to 10 degrees before tdc ? Thanks.
-
-
Will do. Cheers.
-
Please can I have torque settings on headbolts and cam bolts. Thanks.
-
I getting head skimmed but not block. Unlikely the block warps isn't it ?
-
Yh. Tried everything. It only overheated when slowed down from going fast. Was fine going slow. But coolant stunk of fuel. It's all on another post. This was the last thing and one I didn't want to do lol.
-
Overheating. I will do a compression test when all back together.
-
Good. So what would cause this? Could it be running rich ? Because there was a slight hesitation before boost ?
-
Thanks for answer. So the 2&3 clean patches on exhaust side are these a problem ?
-
Is it ? It's been running a few months would it have melted by now if its lean ?
-
No noting is melted or marked. Just looking at colour and clean patches. Good/bad
-
Thank you. I would be lost without this forum ha ha.
-
-
Cheers and how about to undo the bolt ? Car got no compression to help as heads off. Lol
Tapping since head gasket replacement
in 4E-FTE Engine Discussions
Posted
Thanks. The shims deff went bk in order I was looking after them better than my self lol. So what is the noise ? It doesn't sound good for it lol