starlet1991

Looking for a jam or blitz ecu for a glanza

I am currently having an issue with no power in the stereo harness. In the plug shown below there is no power in both the constant 12v (yellow wire) and ignition 12v (red wire). I also found the indicated connector in the second photo identical to the one for the stereo. This is located on the drivers side footwell. Checked with meter for continuity and found that both connectors are on the same harness as confirmed continuity. Can anyone confirm if this needs to be connected to anything? Have found no loose plugs nearby. Would appreciate if anyone can post photos.

Bump

I am currently having an issue with no power in the stereo harness. In the plug shown below there is no power in both the constant 12v (yellow wire) and ignition 12v (red wire). I also found the indicated connector in the second photo identical to the one for the stereo. This is located on the drivers side footwell. Checked with meter for continuity and found that both connectors are on the same harness as confirmed continuity. Can anyone confirm if this needs to be connected to anything? Have found no loose plugs nearby. Would appreciate if anyone can post photos.

Can anyone share some photos of the oem earthing cables in the engine bay? Gone through a complete engine bay rebuild and need to be sure that all the earthing cables are installed.

Should the release bearing provided with the orc clutch be installed as is? Or do you need to use the retaining spring clip found on the oem release bearing?

Anyone knows what this plug is for? situated under drivers side front headlight

Looking for a set of 550cc injectors

Bump

Looking for an aftermarket high flow fuel rail

Anyone?

Can anyone help to locate where these seals from an oem engine gasket set go to?

Currently going through a forged engine assembly with the below specs: - blocked bored to 74.5mm and surface decked - wossner forged pistons - acl bearings - scat rods - arp main cap studs the block has been assembled using engine assembly lube and following tightening torques provided by arp. The assembled crank on block rotated very easily however when the rods and pistons were installed, it seems that there is too much resistance to turn crank. does anyone have an approximate value for torque that would be required by a torqu

Currently going through a forged engine assembly with the below specs: - blocked bored to 74.5mm and surface decked - wossner forged pistons - acl bearings - scat rods - arp main cap studs the block has been assembled using engine assembly lube and following tightening torques provided by arp. The assembled crank on block rotated very easily however when the rods and pistons were installed, it seems that there is too much resistance to turn crank. does anyone have an approximate value for torque that would be required by a torque wrench to rotate an as

Looking for a Set of glanza headlamps in good condition

Looking for a complete turbo kit. Show me what youve got.

Thanks for the information. Do you know what the two upper ports on the throttle body connect to? AC sensor? Can these two ports be removed and blanked aswell?

I am looking into removing the wax stat and idle control valve. If the whole wax stat assembly is removed can you just put a blanking plate like in the image below? Or any other modification is required? when both wax stat and icv are removed, can all the pipes and hoses in the second photo be removed aswell?

If you remove the whole wax stat assembly, can you just do a blanking plate like below picture? Or you need to modify something else?

Looking for a throttle body shipped to malta

Looking for a complete thermostat housing in good conditio

Looking for a complete thermostat housing in good condition

Looking for an ep91 complete engine wiring loom in good condition

Looking for an engine wiring loom, could be damaged as i only need the ecu connectors

bump