tommyep82

I'm using external waste gate and manifold has big runnes, same mani has flowed 350bhp, and yes it's only 95 petrol but still should of made better power, only thing I'm thinking is bad turbo but it's only about a year old and no smoke or play at all???

No lads that's at the fly only 200 at the wheels???

Mapped by ap performance in Galway

Wel lads got my gt starlet mapped the other day and only made 240bhp @ 1.4 bar boost on a tuning developmenps hybrid td04 😠

No boost leaks no falt codes running fine just not making good power, is also lagy for a td04 imo. Can't figure it out, Any input would be greatly appreciated.

Is my exhaust big enough? Think it's 2.25 into 2.5" blitz nur spec

rest of spec is,

td hybrid td04 turbo kit

forged 4e engine, (standard compression)

standard head and inlet

Emanage ultimat ecu

Fmi

fpr

walbro pump

Lambda sensor was not working on dyno witch I have since changed but ecu dose not use lambda at wot

Thanks

The ep82 tps is just an on off signal

Want to run coils so much 😭

How much would full set up cost approx and where do you get the parts. Also any wiring tutorials on anyone doing it?

did you change the coil and igniter mate, fcd wiring look ok?

Speedvision.com in USA mate

Is wg on the right way pal Alan key bolts go to screemer exist side

Try hammer and a punch or grind a line into them and use flat head screw driver mate

No need with a petrol car, if anything your throttle body is all u might need to clean un less your turbo was gone or something

What boost are you running out of interest mate

Sorted lads imagine the jumpers inside ecu for knock sensor were wrong, imagine it was mapped before like this and no problem, but my ct9 hybrid used to run out of puff at 6500 so had no need to rev harder

Thanks I checked both of them that I had on car both look good and still the same

Changed coil dizzy cap rotor every thing the ignition side and it still gives a miss at high rpm I am lost now?

I am using 540 injectors and emanage ultimate could injectors be to big for my set up dumping to much fuel near red line? Mapper said it looked like coil or something but I've changed everything?

They are not that handy to change tho mate and fairly sure they are just an on off switch

Well lads also I can't get the throttle percentage off the laptop when I have it pluged into my emanage ultimate either if this has anything to do with my miss fire or not??

if I unplug the tps and probe the connection to loom I get 5 volts doin it one way and minis 5 the other way using the same earth (middle wire) is this normal?

Thanks lads anyone ever see tps sensor couse this problem maybe

I am getting 5 volts at idle possession, and changes gradually as I open throttle but then goes into minus voltage on the meter when it is near wot. Is this normal as I am getting a Splutter before red line when under full load.

I will mate it's very odd what is happening like spark is breaking down. I had a meter on my tps today and its 5volts at idle possession then reduces as throttle is open and goes into minus voltage near wot is this normal as I'm having a Splutter at 6800rpm at full load but is ok when I bring it up not under full load

I had a meter on my tps today and its 5volts at idle possession then reduces as throttle is open and goes into minus voltage near wot is this normal as I'm having a Splutter at 6800rpm at full load but is ok when I bring it up not under full load

Dizzy rotar and leads are only about a year old, New plugs, coil is next to try and earths don't know after that head is melted

Well lads do the mechanical part of the distributors on the 4efte engine give any problems?

Was getting car mapped to and had a Splutter past 6700 ish under full load, but if u bring power on easy it will rev out. Any suggestions car is driving and boosting perfect apart from that?

Keith mcmullen in cit beside you man. Or wcp in kerry

No lad they are different, you can swap just the Window motors over alright