Chand

^^ help

This is a common problem on standard setup It's because it has no allowance for play in the turbo oil feed mate As said above I would invest in a braided oil feed as that will most likely be where it is leaking from It will more than likely had a slight crack inside which will allow once pressured to bleed out

Bump

Thanks for advice guys il see it I can sort something out my end Ricky if not I will send it your way Few other questions then With idle compensate valve on the left side of the standard inlet I no it can not be fitted but do I have to link out the plug etc? I've finally removed the sensor for a/c does that also need to be linked out or is it just a case of unplug happy days? Two vacuum pipes that feed power steering rack do they both still need vacuum as one was into inlet and other was into throttle body on standard inlet? Then there was a vacuum that came off throttle body on standard inlet and pipe connected to engine next to where heating into car does that still need a vacuum a also? Help please Chand

This is what I was talking about thank you Someone actually understands what I mean it's no hard to look at the pic lol But yes it looking like I'm going to have to weld another plate else where as the standard wall thickness of the inlet will be too thin of a material to seal and yes mate I would use a copper washer and ptfe tape to make sure it's a air right seal But yes it was obviously not taken into consideration when welded on Yeah this might be another option thanks for advice Yes mate this is correct :/ not good

The temp sensor that fitted into the front on the standard inlet mate And what you mean what seal?

If you can see where you welded the plate for vacuums the sensor will not fit start in as it hits a velocity stack mate :/

Hi all Just a quick one I'm in process of fitting my new race tech inlet but where race tech have welded the plate for vacuums it won't allow me to install the inlet temperature sensor Just wondering if anyone else has this problem or do they just not run that sensor? And if there's other sensors that I don't have to run from stand inlet that would be a great help aswell Thanks Chand

Gutted ok mate no worries

Pm me best price for bonnet pins set

Yeah il have one mate pm me ya PayPal

How much for exhaust rear rubber mate?

You still have shafts mate?

I have also purchased a race tech inlet manifold and removed oem inlet I don't need to mess about this coolant hose and my inlet misses coolant pipes there's a couple of vacuums that came off the engine it self are they still needed? One goes to the pipe next to coolant hose to the engine and second comes from the water pump pipe I believe and is that vacuum needed or can I just put the pipe from water pipe onto where another pipe was that went to inlet if you get me Any ideas Thanks Chand

Bump

4efte inlet manifold gasket brand new

These Cj performance pulleys mate?

As above after both drivers and passengers bride rails Not sure how much they go for but get in touch Chand

Sold!

Thanks mate I bought mine about a year ago for £500 without rails So I think its a very fair price Thanks Chand

Yes mate I was running standard rails and just drilled holes where needed and bolted them to it Or could use flat bar and weld it etc Up to you Chand

Just come seat rails mate but if you already have some rails just adapt them to suit seat Thanks Chand

You still got dials?

Still here

I haven't got any pics of it will try get some tomorrow mate or Sunday but as whitenoize said if he got his £103 brand new what's the point