Jump to content

Rich

Member
  • Content Count

    860
  • Joined

  • Last visited

Posts posted by Rich

  1. Yeah its alright, still needs anti-lift kit and strutbraces etc :drunk2: the thing is the tracking is probably out again as the pricks who changes my tyres and done the alignment didn't even notice the hub was coming lose from the strut or they did and didn't bother letting me know! :surrender:

  2. I'm guessing you'll be in Bills car then?

    1) JAG - SR (N)

    2) Mikey Jay - Paseo (N) & Joey (N)

    3) SiCaln & Mrs

    4) Alexgtadv - GT

    5) Al (N)- Pricklet & Sophie (N)

    6) Josh - Civic (N)

    8) Rick (N)

    9) Bill (N)

    7) Rich (N)

  3. Can I join in Please? can I? can I?...

    77.2 whp... lol ^^

    Spec was...

    Corrolla inlet

    DIY Induction kit

    Decat (lost torque with that)

    Glanza S Injector (running lean 16:1 :D)

    Powerloss Backbox

    Now I have a decent cat-back with sports cat :D

  4. If i have these mods.

    Full 2inch Zort with decat. Middle box and back box

    Ram Air intake with heat shield

    Rolla Mani

    Advanced Timing

    How much more will the mani give.

    Total Bhp = ???

    Thanks

    Erm... who knows but I wouldn't say it gives you anymore power as such, it helps the motor increase in efficiency therefore increasing overall performance by a percentage. A 4-2-1 is designed to give you a broader torque range which you will notice.

    RPM * Torque/5252 = Power (ish)

    I'm still up for it and I'm sure we can get atleast 5 people (we had 10 on the list but I'm sure there will be no more than a few that pull out).

    I'm going to let Rich buy one first though and let us know the results, money is tight at the moment, so I'm not going to gamble £250 and "hope" that it gives a good increase in performance.

    Thanks ^^

  5. You pretty much have to remove the bottom half of the dash 2 large screws underneath either side and 3 smaller screw behind glove box at the top (open glove box to get at them they are near the clip) pull off at the sides to unclip. Its the whole panel including speaker etc.

  6. I just take the glove box off and disconnect the ECU itself, leave it for 10-20 mins reconect switch on (if its worked it will almost stall the engine) leave for 5 mins on idle switch off or go for a drive...

    Also Have you check for crackes in the exhaust manifold or anywhere?

  7. Not yet the weather has been shocking most weekends so not really had much chance.

    The thing with the system you have is that its got two largeish silencers which help, I would have chosen to get a baffled decat but a sports cat means theres a lot less messing around. Probably get some of the system redone if I get some extractors made up in the future...

    When it gets through the MOT the main priority will be getting the exterior done properly after that who knows.. :)

  8. MOT Prep

    Right got my MOT coming up this month so thought I'd get some prep done.

    First off I got a sports cat to replace my decat :) I actually prefere it now to what it was, too raspy for me with a decat. No pictures as well its under the car and it snowed :D

    Next up was some new tyres and alignment. Went for some Toyo Proxes this time as the parada spec 2's were about as usufull as a chocolate tea pot in the wet ;)

    Heres the alignment sheets -

    Before

    align_1_before.jpg

    After

    align_1_after.jpg

×
×
  • Create New...