GordR Posted May 31, 2016 Share Posted May 31, 2016 The wiring knock sensor wiring from the end of the injector loom down to the sensor has broken.Can anyone suggest type of wiring required and best place to get hold of it? Quote Link to post Share on other sites
patman Posted May 31, 2016 Share Posted May 31, 2016 You definitely want shielded wire I know that much Quote Link to post Share on other sites
Turbo Goose Posted May 31, 2016 Share Posted May 31, 2016 Just just used some 0.5mm screened cable. Just make sure the screen is earthed at one end.Could only get hold of 2 core but just used one of the cores and the others just sat there not wired in as a spare Quote Link to post Share on other sites
patman Posted May 31, 2016 Share Posted May 31, 2016 Hang on goose I swear you gave me some of that wire you had as I had this problem once and you sent me some if I remember correctly? Quote Link to post Share on other sites
Turbo Goose Posted June 1, 2016 Share Posted June 1, 2016 Quite possibly mate as i sent somebody some. Did you get it fitted in the end? Quote Link to post Share on other sites
patman Posted June 1, 2016 Share Posted June 1, 2016 Yes I did thanks mate and worked a treat and still all good aswell 👍🏻 Quote Link to post Share on other sites
Stu Posted June 7, 2016 Share Posted June 7, 2016 Yeah as above, as long as its braided you will be fine. Don't connect the braid to ground at the sensor end though, just connect it to your original braid where it broke off. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.