EP70-PT Posted September 21, 2016 Share Posted September 21, 2016 (edited) Need to find a wire that has 12v when the high beams are on.. My N/A clock wiring doesn't go well with the paseo clocks,I don't have the same wiring as other people that did the conversion here for some reason... My high beam indicator is on when lights are off, off when low beam is applied and dimmed on high beamm.. Idk why it stays on when the lights are off so I need to find another source for it... Edited September 21, 2016 by EP70-PT Quote Link to post Share on other sites
TrisK Posted September 21, 2016 Share Posted September 21, 2016 Just put a relay in. A 4 pin NO (normally open) relay should do it Quote Link to post Share on other sites
EP70-PT Posted September 21, 2016 Author Share Posted September 21, 2016 Maybe my actual relay is gone too... No? Quote Link to post Share on other sites
Flaminsam Posted September 22, 2016 Share Posted September 22, 2016 The headlights have a permanent power to them if i remember right. Then it's the switch in the car that gives them an earth to turn them on. Quote Link to post Share on other sites
EP70-PT Posted September 22, 2016 Author Share Posted September 22, 2016 Problem solved, headlights ON had a switched ground, had to do a separate circuit for the HIGH BEAM on the paseo clocks... Something a bit like this:ALL GOOD NOW! Thanks guys Quote Link to post Share on other sites
EP70-PT Posted September 22, 2016 Author Share Posted September 22, 2016 Problem solved, headlights ON had a switched ground, had to do a separate circuit for the HIGH BEAM on the paseo clocks... Something a bit like this:ALL GOOD NOW! Thanks guys Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.