new to this need advice on conversion

[DonnieEP91]

how easy is it to drop a glanza lump in a n/a

[Ollieh17]

Been covered a million times on here. Search it

[akyakapotter]

Just done a quick search bud first one a came across gave this hope if helps do a quick search with the form you'll find every thing you need cheers nick

isn't a big job as Richard said

parts you will need

full loom dash and engine

exhaust system

turbo and manifold

cat

intercooler and pipe work

knock sensor check your block first if you have the hole or ya will need to drill it to fit the knock sensor

thermostat housing as has extra feeds for running water through turbo not essential but if ya can get it fit it

injectors

sump with oil feed return

throttle body as turbo ones are slightly bigger or if ya can get a full inlet get it

map sensor

fuel pump starlet one doesn't flow fast enough

boost gauge again not essential but handy to know what boost your at

rocker cover has extra crank case breather

ecu

standard actuator make sure ya get hi low boost button and run it on low boost

probably bits im leaving out but ya get the jist of what parts ya need gearbox side of things your box should do the job ya might need to use your flywheel and clutch setup