Terry1.3GTT Posted August 13, 2017 Share Posted August 13, 2017 (edited) Looking for the following bits to really help the new build come along......Crank pully bolt - (sorted)Thermostat housing cover/ or complete part ..dont need sensors - (sorted)Gearbox to engine bolts for putting block to engine standUprated inlet manifoldThese bits to start but might add some bits to the list.Cheers Edited August 14, 2017 by Terry1.3GTT Link to post Share on other sites
SpikeyJp_68 Posted August 13, 2017 Share Posted August 13, 2017 Got a crank pulley bolt and washer in Ireland Link to post Share on other sites
_shaun_ Posted August 13, 2017 Share Posted August 13, 2017 I've got crank pulley bolt and thermohousing. Can post them or bring to jae Link to post Share on other sites
Terry1.3GTT Posted August 13, 2017 Author Share Posted August 13, 2017 If you bring them to JAE i will have them deffo. Link to post Share on other sites
_shaun_ Posted August 13, 2017 Share Posted August 13, 2017 Sounds good to me mate I'll look them out just let me know if you need anything else loads of stuff here. Link to post Share on other sites
funny onion Posted August 14, 2017 Share Posted August 14, 2017 Also have crank pulley bolt and thermostat housing, can bring to JAE (just in case shaun cant find them) Link to post Share on other sites
Terry1.3GTT Posted August 14, 2017 Author Share Posted August 14, 2017 Ok perfect Shaun and thanks Funny Onion that would be cool.Still afterGearbox to engine block bolts (so i can put this block on a stand)Also looking for uprated inlet mani Link to post Share on other sites
TimD Posted August 14, 2017 Share Posted August 14, 2017 The stock gearbox bolts aren't long enough to use with an engine stand. I can't remember the bolt spec, but I'm sure I just measured it and then bought a pack of 5 or so from Screwfix. Some were too long, so I packed the space out with washers. Link to post Share on other sites
Terry1.3GTT Posted August 14, 2017 Author Share Posted August 14, 2017 Ahhhhh cheers dude good point, think they are m10's if anyone can shed any light on that one??? Link to post Share on other sites
TimD Posted August 14, 2017 Share Posted August 14, 2017 Pretty certain they are a fine pitch thread Link to post Share on other sites
Terry1.3GTT Posted August 14, 2017 Author Share Posted August 14, 2017 Il get a couple of bolts to try first Link to post Share on other sites
Terry1.3GTT Posted August 14, 2017 Author Share Posted August 14, 2017 (edited) Also needSteering rack passanger side bracketEngine hooks ( lifting engine) Edited August 15, 2017 by Terry1.3GTT Link to post Share on other sites
_shaun_ Posted August 15, 2017 Share Posted August 15, 2017 Take a picture of the bracket mate I dunno if there the same on the gt to glanza Link to post Share on other sites
Terry1.3GTT Posted August 15, 2017 Author Share Posted August 15, 2017 They are the same. Do you have one? Link to post Share on other sites
_shaun_ Posted August 16, 2017 Share Posted August 16, 2017 I'll check if the scraps been lifted tommorow. Link to post Share on other sites
Terry1.3GTT Posted August 17, 2017 Author Share Posted August 17, 2017 Any joy on the bracket Shaun?? Link to post Share on other sites
Recommended Posts