tez Posted July 14, 2011 Share Posted July 14, 2011 helloright i set my actuator at 1 barbut i only seem to be getting 0.8/0.75 bar on my gauge.The car feels quickbut seems to be a good kick of boost then backs offCould this be my turbo?or a leak?or my actuator(hks)?when fitting the HKS it felt tight and not loose?any ideas?CT9 turbo Quote Link to post Share on other sites
WallaceGlanza Posted July 14, 2011 Share Posted July 14, 2011 Adjust the actuator again and then see if you can hit 1 bar - assuming you have got other supporting mods (fuelling something to remove fuel cut etc?) Quote Link to post Share on other sites
tez Posted July 14, 2011 Author Share Posted July 14, 2011 Adjust the actuator again and then see if you can hit 1 bar - assuming you have got other supporting mods (fuelling something to remove fuel cut etc?)all supporting mods,fmicblitz decat & exhausthks actuatorported manifold and turborelocated filterJAM ecuWhat is standard boost in bar?do the ct9s seem to back off at the top end of revs? Quote Link to post Share on other sites
akyakapotter Posted July 14, 2011 Share Posted July 14, 2011 mine is doing the same boost up to 3500 then nothing i think its due to my exhaust mani gasket blowing though well i hope it is hope you get this sorted Quote Link to post Share on other sites
string Posted July 14, 2011 Share Posted July 14, 2011 prob get a ebc and have ya actuator set at like .6. thats how i ran my hybrid set up. then controllers doin all the work and ya actuator will hold boost better. Quote Link to post Share on other sites
tez Posted July 14, 2011 Author Share Posted July 14, 2011 it only backs off slightly at higher revs.(not at 3.5K)theres no leaks as i carnt feel anything(hipefully)would it be a good idea to me to get a MBC or EBC and up the boost from that?or adjust actautor at 1 bar? Quote Link to post Share on other sites
string Posted July 14, 2011 Share Posted July 14, 2011 try actuator but most people use a boost controller over .8 i think. also the ct9 will run out of puff high end. Quote Link to post Share on other sites
tez Posted July 14, 2011 Author Share Posted July 14, 2011 try actuator but most people use a boost controller over .8 i think. also the ct9 will run out of puff high end.Thanks dude. Reset actuator. Was set at 124mm oppsNow at 121/120 Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.