Pcv valve

[Ep91kez]

Hey guys after abit of advice. I need to replace my pcv valve as I accidentally snapped it =[ and don't have a clue how to remove it.

Any help would be great cheers =]

[davehart]

Very easy they just pull off.

The old one may be brittle so be careful not to drop any bits down the hole.

[Ep91kez]

It fell down the hole =\ the cam cover is off the engine is there any way to get to it or is it new cam cover? Cheers for the fast reply =]

[waderz06]

I had the same problem but just used needle nose pliers and managed to get the remaining bits out.

[akyakapotter]

I had to remove the old rubber bung it snapped into bits

[Ep91kez]

I do have another cover but it looks to of had a catch can on it and where the pcv valve usually fits its had a thread put in and a different type of breather thing (vague I know) screwed in to it looks like I could just connect that to the inlet but not sure as I dosent have the valve now it's just a straight through breather valve =\

I am quite new to all this so sorry or my crap knowledge lol

And thanks for the replys =D

[akyakapotter]

That's a race spec cover set up

Edited March 24, 2013 by akyakapotter

[Ep91kez]

This is my cover if I've uploaded it correctly lol. Would it work connected as a standard set up from the standard breather to the standard recirc valve and from the non standard breather to the inlet?

[Ep91kez]

Sorted now guys thanks for all your help =] just ended up buying another cover with pcv in it haha

[Frankieflowers]

On 3/24/2013 at 3:10 PM, akyakapotter said:

That's a race spec cover set up

http://i164.photobucket.com/albums/u36/akyakapotter/DA219A09-089B-460F-8C4E-1533C94E9289-299-000000342509BA42.jpg

Hello! How did you put that 90* in instead pf the plastic pcv? Thanks