daniel_g Posted June 4, 2013 Share Posted June 4, 2013 Alright, so i have changed all the looms in my GT because a previous owner had butchered them. But i have just noticed when relocating my ECU that there is a snipped wire which doesn't go anywhere... Anyone know where its supposed to go ?Or why this wire would be cut ? Car starts and runs fine, cant properly test because no MOT etc.No EML light or any fault codes. Any help appreciated , heres a pic. Quote Link to post Share on other sites
Fozzie Posted June 4, 2013 Share Posted June 4, 2013 According to the wiring diagram, that wire is +B1; Switched battery power (12v) and the one below it in the same plug, does the same thing. I guess because they do the same thing you only need one of them, but I'm not sure why there is 2 at all if that's the case... :/ Quote Link to post Share on other sites
daniel_g Posted June 4, 2013 Author Share Posted June 4, 2013 Ahh well thats not to bad if thats the case. So it must have been used to power something then. I couldn't find a wiring diagram to check. One of the lads in work reckoned it was to get round the 180 kph speed limit, but that was just a guess. Cheers Quote Link to post Share on other sites
daniel_g Posted June 4, 2013 Author Share Posted June 4, 2013 Legend Shaun, clicked and saved haha. Still wonder where it goes but i cba opening up the loom. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.